Ohio-Ed

Gift Premium Subscription To Ohio-Ed

Join Date:

11-18-2008

Last Activity:

06-13-2014 9:05 PM

19 Likes on 18 Posts 

    ABOUT ME

  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: Ask Your Welding Questions Here!!! on 01-10-2014 at 12:20 AM
    Too bad he didn't hit it with a wire brush while it was still hot... would have cleared up the
    discoloration. If no leaks, you should be fine for a boil kettle. Sent from my SCH-I535 using
    Home Brew m...

  • Posted in thread: Keggle ''extension'' on 12-24-2012 at 01:42 PM
    If you're going to be using a pid with your rig then you could set it to right under your boil
    temp and then raise it up slowly keeping a close eye on any possible boil overs. Its not a
    perfect soluti...

  • Posted in thread: Keggle ''extension'' on 12-24-2012 at 03:21 AM
    Welding a keg is not as simple as many welders think (this I'd discussed in many threads here
    on HBT). Best chance of success is if the keg is TIG welded, and the back side of the weld is
    purged with ...

  • Posted in thread: Keggle ''extension'' on 12-23-2012 at 02:39 AM
    It is definitely possible to have a boil over with a 5 gallon batch in a standard american
    sanke. I'm sure you can guess how I know this. And doing a 10 gallon batch certainly requires
    monitoring. I t...

  • Posted in thread: Best way to cut the top off of a keg on 11-19-2012 at 05:17 PM
    Gloves on rotating equipment like an angle grinder are not such a good idea under most uses and
    circumstances... Safe Work ProceduresSafe work procedures are formal, written instructions
    which describ...

  • Posted in thread: Best way to cut the top off of a keg on 11-19-2012 at 12:30 AM
    Wait, that was the beer again. Honestly to each his/ her own. And like I always say" any job,
    big or small, is worth doing well, or not at all." Bravo on you pretty keggles I am humbled by
    your dedica...

  • Posted in thread: How to block a hole in stainless? on 10-04-2012 at 06:17 PM
    Have one welded. While you're at it, take advantage of the situation and add a dump valve to
    the otherEd

  • Posted in thread: Garden hose water... how bad is it? on 06-27-2012 at 12:39 PM
    If you are going to dedicate a hose you can get food grade tube fairly inexpensively, get tube
    wide enough that you can get hose couplings that will fit. There are reducers that work drip
    systems and ...

  • Posted in thread: Electric burners - Any builders out there? on 03-17-2012 at 01:44 PM
    Looks good, but I do have a question.What are your thoughts on how you will drain the pump when
    you're finished?Ed

  • Posted in thread: Using 2 pumps at the same time on 03-14-2012 at 01:26 AM
    You should be able to run 2 on a 15 amp circuit with no problem.(Unless you have a lot of other
    stuff on the same circuit)Ed

0 COMMENTS
POST A COMMENT