Last Activity:11-21-2016 9:52 PM
7 Likes on 6 Posts
Posted in thread: FastFerment conical fermenter?????? on 11-21-2016 at 09:52 PM
I reuse the yeast most of the time. I never wash it or pour it into a jar. I just take the ball
off the fermenter, drain a little of the beer and put the bung on it. Put it in the fridge as
is. I thin...
Posted in thread: FastFerment conical fermenter?????? on 05-14-2016 at 01:10 AM
The leak is between the union and the grey collection ball coupler. Where my finger points in
the picture. Everything else looks good. The o-ring is there and I re-seated it for safe
measure.Kind of l...
Posted in thread: FastFerment conical fermenter?????? on 05-13-2016 at 12:11 AM
Picked up one of the FF a week ago and put it together for a leak test. The union fitting leaks
like crazy. I took the knob off and tightened the internal valve but that didn't help at all.
Posted in thread: FastFerment conical on 03-20-2016 at 12:27 AM
For people who bottle directly from their FastFerment: How do you deal with the trub that ends
up on the sloped sides of the fermenter that has not fallen down into the collection ball? As
soon as I m...
Posted in thread: FastFerment conical fermenter?????? on 02-01-2016 at 03:41 AM
Ok so this just happened, I was mounting the brackets onto my new stand and the bolt snapped.
Either the pilot hole was too small or not deep enough. Does anyone know the size of the
bolt?If the socke...
Posted in thread: FastFerment conical on 01-12-2016 at 02:04 AM
Ok here is the 1"heres the male end for $6 the female end for $11... This would allow a
person to ditch the union, You would gain a couple of inches in overall length though which
would be an issue ...
Posted in thread: FastFerment conical on 01-08-2016 at 03:52 PM
I have used mine with wine as have others. It certainly works fine for it. The only issue I had
along with some on winemaking talk is the fine lees when it comes time to bottling. The same as
Posted in thread: FastFerment conical fermenter?????? on 12-30-2015 at 12:56 AM
I would skip #1. Everything else looks good. My opinion; Some folks get too hung up on trub
removal before primary even starts. Trub reduction and clarity will come later.I do this to
make my yeast co...
Posted in thread: FastFerment conical fermenter?????? on 12-28-2015 at 12:29 AM
Don't sand the top until you verify you need to. If the top most surface ring is noticeably
smoother than the rest of the fermenter and very flat, then you you have a newer version that
won't need it.
Posted in thread: Refrigerated Conical on 11-03-2015 at 07:56 PM
This is what you are looking for, I think. exactly, only those are thermoelectric, i'm talk
refrigerant like a fridge.I've been testing with thermoelectric ice probes anyway and though
they are an en...