Last Activity:08-01-2013 11:53 PM
5 Likes on 4 Posts
Posted in thread: Tight Scew on regulator!! on 04-20-2009 at 07:38 PM
PB buster to loosen it, and then clean/sanatize it quick before re-assembly?
Posted in thread: 20 oz or 5 lb co2 tank??? on 04-16-2009 at 07:42 PM
If you are looking at a 5 pounder option, consider larger if your setup won't be hindered with
the size of the tank- I say this because it is cheaper by volume to fill a larger tank then a
small one (...
Posted in thread: Firearms afficionados on 04-09-2009 at 08:16 PM
Own Springfield XD sub-compact 9mm- LOVE IT! My only complaint are the safety indicators- the
top one works as it's supposed to, but the front and rear indicators to show that a round is in
Posted in thread: Force carbonating. NEED HELP!! on 04-09-2009 at 08:01 PM
I carb at 30psi for 2-3 days, then drop the pressure to about 18 for the rest of the week. The
beer is drinkable then, but gets better a week or two later. The beer carbonates fairly
quickly, but it t...
Posted in thread: Kegerator Building Tips on 04-09-2009 at 07:57 PM
2 3/4 hole saw from lowes; I used aluminum tape as well (was going to get HVAC but it was more
expensive). Post your results in the 'Show us your kegerator' thread!
Posted in thread: Keg diagnosis help on 04-09-2009 at 07:55 PM
Balancing your system is always hard to start off with... Hope it works out! Keep us posted
:mug:PS How's that tank treating you?
Posted in thread: Leaving immersion chiller in boil on 04-09-2009 at 07:38 PM
I think I may be the only brewer on these forums who does not boil their immersion chiller.
Boiling it for 15 minutes or longer, or any length of time, really, just seems like complete
Posted in thread: First Label for my First Brew on 04-07-2009 at 08:21 PM
that for you
Posted in thread: Kegerator Building Tips on 04-07-2009 at 08:18 PM
I would go with a hole cutter if I were you. Drill a small pilot hole dead center, and have at
it. You will have jagged edges with a spade bit. I would definitely add a piece of wood for
backing to su...
Posted in thread: INOP keg! How do i fix?? on 04-06-2009 at 07:26 PM
Let us know how the O rings work- Pressurize it to 20+ PSI and let us know if/where it leaks.