Last Activity:08-06-2015 3:30 AM
Likes Given: 2
Posted in thread: New e-HERMS build, questions. on 08-05-2015 at 10:11 PM
Nice progress. I assume this is the case, but wanted to confirm for the benefit of others that
you are going to be installing a cable clamp/strain relief where the power supply cord enters
Posted in thread: Venting idea on 07-17-2015 at 04:39 AM
I wish I was standing in your basement because I think we'd probably have it all figured out by
now.As others have said, you can't vent into a drain; there's a trap under there that is full
of water. ...
Posted in thread: Yet another 3 tier rig--dialup warning large pix on 12-28-2012 at 05:26 PM
That tube doesn't even get mildly warm. There is a plastic switch mounted in the top of the
vertical tube which is not affected by the HLT burner.
Posted in thread: Yet another 3 tier rig--dialup warning large pix on 09-25-2012 at 05:52 PM
I recently thought more about the years of accumulation of who-knows-what inside the CFC. Just
for kicks I ran a gallon of hot water mixed with Oxy Clean through the CFC. I let it sit in
there for a f...
Posted in thread: Yet another 3 tier rig--dialup warning large pix on 06-07-2012 at 04:07 PM
I definitely agree that the immersion chiller brings with it less risk of contamination. I also
think that as it drops the temp of the wort, more of the hot break gets a chance to settle out
and gets ...
Posted in thread: Yet another 3 tier rig--dialup warning large pix on 06-06-2012 at 09:15 PM
I do sanitize before each use. I know the wort is going in there boiling hot, but by the time
it exits, it is room temperature so whatever nasties might lurk there aren't going to be
affected by tempe...
Posted in thread: 6 polished stainless shank trim rings on 04-25-2011 at 10:17 PM
Rings are sold pending payment. Thank you.
Posted in thread: 6 polished stainless shank trim rings on 04-25-2011 at 06:46 PM
Bought, but then not used for my project.Would make a nice and inexpensive appearance upgrade
for your dispensing setup. $2 each. Much nicer looking than the black plastic ones.Cheap to
ship in a padd...
Posted in thread: Bar Rebuild on 03-24-2011 at 06:29 AM
I feel qualified to comment since I lived in the fraternity at Washington State between 87 and
91 when it was considered one of the top party schools in the nation. 8+kegs in one night was
Posted in thread: Yet another 3 tier rig--dialup warning large pix on 12-29-2010 at 06:46 PM
Local steel yard, very thin gauge 2" square tube but I don't recall what wall thickness.You
want dimensions for the vertical piece, for the shelves, or????