Last Activity:12-08-2013 2:38 PM
Likes Given: 9
56 Likes on 48 Posts
Posted in thread: Co2 paintball adapter not working on 12-08-2013 at 03:44 PM
Your threads Are either messed up or you need to lube the tank o- ring.
Posted in thread: New to kegging, faint hiss from relief valve on pin-lock Corny on 12-08-2013 at 03:39 PM
Try homebrewing.org I saw they have used pin lock lids for $1. Even if you buy 5 it's still
cheaper than a new relief valve.
Posted in thread: Wrong Keg Post on 12-08-2013 at 03:27 PM
Not all of those pictures on that website are accurate. Many look the same on the outside. The
threads on the inside are different. Many times the firestone posts will have "hanson" stamped
into the p...
Posted in thread: Good hops to complement Chinook? on 12-07-2013 at 02:25 PM
I think Columbus, simcoe, even cascade go pretty well with chinook.
Posted in thread: Suggestions for dip-tube solution in mash tun with a "bump" in the middle on 12-07-2013 at 03:12 AM
If you don't want a dip tube going all the way across you would need a 180 degree dip tube that
bends back around and then goes down.But I think you are overthinking things. What is the actal
Posted in thread: does shank size really matter? on 12-05-2013 at 01:08 AM
The other part you need to remember is you need about 3/4" for the beer nut to attach the
tailpiece. So while the shank length might be 4.25" you only have about 3.5" of thread left.
Posted in thread: Weldless ketle valves and immersion chillers on 12-04-2013 at 03:48 AM
The kettle valve is plated brass, so it should be ok with the aluminum.
Posted in thread: Equipment I didn't know I had!! on 12-04-2013 at 03:21 AM
You won't be able to use those tanks. If they were meant to fill smaller paintball tanks, the
larger tank is equipped with a siphon tube. This will put liquid co2 into the regulator instead
of gas. Th...
Posted in thread: Weldless ketle valves and immersion chillers on 12-03-2013 at 03:51 AM
Use the "kettle valve" brand valve. It doesn't have a protruding coupler on the inside of the
pot it uses a nut and is lower profile.
Posted in thread: Someone needs to open a CO2 supply on/near the upper east side in NYC on 11-21-2013 at 03:39 AM
Look for a fire extinguisher service company. They are all over the city and will fill co2