Huey

LATEST ACTIVITY

• Posted in thread: Advice on packing wine in suitcase... on 03-02-2013 at 03:23 PM
  Those 'wine diapers' should work fine for a few bottles per suitcase.If you end up wanting to
  get more wine the wineries should have some decent packing options for a separate checked bag
  or should be...

• Posted in thread: HomeBrewTalk 2013 Big Giveaway! on 02-07-2013 at 04:14 PM
  I'm in. Thanks sponsors!

• Posted in thread: Carboy/ Keg Cleaner Giveaway on 06-01-2011 at 04:49 PM
  in!

• Posted in thread: Project Locator on 05-30-2010 at 08:47 PM
  Here's a write up I did for etching pint glasses: section, level 1.

• Posted in thread: DIY Pint Glass Etching on 05-11-2010 at 10:00 PM
  You could also try using regular paper. They say you can use 84 brightness 20lb paper (or less)
  and expose it for 3 minutes.Exposure Times / Tips: seems to be the recommended product and I
  had some ...

• Posted in thread: DIY Pint Glass Etching on 05-11-2010 at 03:50 PM
  Keith - when you say you're sandwiching the stencil/transparency between two pieces of acrylic,
  are you leaving the rear transparent? Only one side of the stencil should be exposed to light -
  even if ...

• Posted in thread: DIY Pint Glass Etching on 05-11-2010 at 03:47 PM
  You do have a layer of solid black directly behind the stencil so it isn't getting light from
  behind? I'm pretty close to sea level and UV radiation does increases about 5% with every 1000'
  of elevati...

• Posted in thread: DIY Pint Glass Etching on 05-11-2010 at 01:50 AM
  rv6tc,Is the stencil and stencil pro material pressed together tightly?What I did was I carried
  the stencil apparatus outside covered in a towel, removed the towel for 20 seconds, and then
  covered it ...

• 

  Added a new Photo on 05/08/2010

• Posted in thread: Let's talk about Foam Control drops (aka Fermcap) on 05-06-2010 at 09:13 PM
  How far up the sides are people filling carboys when using Fermcap S?I did a three gallon IPA
  batch in a three gallon carboy (the three gallon mark on mine is right where it starts to taper
  at the top...