Hogcrewer

LATEST ACTIVITY

• Posted in thread: Single Tier eHERMS TriClamp (mostly) build on 02-11-2013 at 01:23 PM
  You made your own temp probes?.......Hhhhmmmmm now that has me thinking....did you flare the
  end before you welded/soldered it to the TC end cap? I know your going the Adrno route.....Will
  these also ...

• Posted in thread: New RIMS Brewery Up and Running on 01-28-2013 at 04:10 AM
  Damn nice......

• Posted in thread: Single Tier eHERMS TriClamp (mostly) build on 01-27-2013 at 04:00 AM
  Hey keep posting. I am currently using propane for my heat source. But at -40 it is becoming a
  PIA. I downloaded Kals pdf. I currently have a HERMS set up. But have been looking at a RIMS
  set up also....

• Posted in thread: Temp. Probe wiring question on 01-26-2013 at 03:24 PM
  Does anyone know the name of the stainless steel protective cover over the wiring? Seeing if I
  can score that stuff off EBay for wire protection.....

• Posted in thread: Temp. Probe wiring question on 01-26-2013 at 03:19 PM
  SCORE!!!! Those are sweet. I never have thought about that type of covering on the wires. Hey
  JRems, what key word(s) did you use to find them on DBay?

• Posted in thread: Budget 2 vessel e-herms build. What controller? on 01-26-2013 at 03:16 PM
  Hey PJ, hope you are feeling better. You are a asset. Hey, I have had the same motor for a
  couple of years now. My intended use was to stir the Mash Tun while the grain is
  mashing....didnt do it.How d...

• Posted in thread: Ebay stir plate speed controler wiring ebay on 01-26-2013 at 04:30 AM
  Yep, living in North Pole Alaska. Will take beer bribes to get anyone on Santas "good" list. As
  a matter of fact we hang out at the same lounge. The Elf's Den..lol.There is a few of us
  homebrewers up ...

• Posted in thread: Ebay stir plate speed controler wiring ebay on 01-25-2013 at 12:10 PM
  Hey Wheelspin...You still have the link to that seller?

• Posted in thread: Cloning kal on 12-28-2012 at 01:20 PM
  Hey Sils, like you I am starting to pull the trigger on an Electric build. I bought Kals book
  for ref. Have you been keeping a XLS spreadsheet or something of that nature that shows where
  you purchase...

• Posted in thread: Propane to all out electric build on 12-23-2012 at 07:50 PM
  I use the same element enclosure for my distillation. I am thinking about converting to
  electric now. Your build makes thing look a little easier. Deff has my attention.