Derrin

NEWEST ADVERTISEMENTS

• Brewers Hardware????
  Hi Guys,First off: My sincerest apologies for those of you that I've let experience my own
  growing pains. Brewers Hardware is not running the way I want it to be, my communication sucks
  right now and ...

• Temp sensor fluctuation
  Thanks for the compliment Malfet!Layne, I sent you the actual spec sheet from Vishay on the
  thermistors used to build the probes and the coefficients I came up with and have been using
  are here: BCS T...

• Just finished my sculpture!
  Really well done! I have to agree that dented edge is pretty cool.

• 5000ML (5L) stir plate build
  Very well done!

• Square Tubing Size
  I built my first one out of 1X2 16 gauge (.065 wall). The rest I've built with 2X2 16 gauge.
  Haven't tried 1.25 square, but I will say square tubing is much easier to fit up than
  rectangle!

• New 1/2" Full Bore Barb Fittings
  After looking high and low for a 1/2" barb fitting that didn't choke down to 3/8", I finally
  had one made: Side X side with a standard 1/2" hose barb: of bore diamters: full bore hose
  barb

• Whirlpool Attachment Question
  Yea, but short of fabricating all that (which I can't even visualize), I'm wondering how well
  it works as designed? Are there any "simple" modifications that need to be made so the
  whirlpool not only ...

• Whirlpool Attachment Question
  In my 26G kettle, I stood the IC about 2" off the bottom of the kettle and that seemed to
  really help with the cone pile formation. I built a copper whirlpool return that was my shelf.
  I wish I had pi...

• New Brewery Test Batch #1
  Are those 3/4" TC barbs for your 1/2" hoses?Yes they are.

• Fixing a wort chiller leak
  "may be" and "is" leaking is two different things. I'd remove the kinked spot anyhow to allow
  adequate water flow and put in a coupling. Run water through at normal pressure and verify no
  links afterw...