Last Activity:12-07-2014 11:59 PM
Likes Given: 7
4 Likes on 4 Posts
Posted in thread: Kegerator that's been sitting, sanitary question on 08-31-2014 at 09:26 PM
Hey,Haven't been drinking much beer lately. Drank too much in the summer and was just put off
by it.Does. Not . Compute.As for your lines, let a strong PBW solution sit in it for 24 hours.
Flush with ...
Posted in thread: Best solution for a really cloudy EIPA? on 08-31-2014 at 08:39 PM
Hey everybody,So I kegged my EIPA last night, very hoppy and young/green tasting, which is ok,
all that will (should) mellow out with a bit of time.It was VERY cloudy, however, which I am
thinking is ...
Posted in thread: Name/handle change? on 08-18-2014 at 06:03 PM
Is this possible?Cheers!
Posted in thread: S-04 fermented a bit warm...opinions? on 08-05-2014 at 08:32 PM
Thanks guys!So you think leave it one the yeast for a bit longer to help clean it up?It's
fairly well hopped. 2.5 oz of 8.7% Target @ 60 and 1.5 oz of 6.7% Challenger @ 15 and 5 each.
Estimated IBU's ...
Posted in thread: S-04 fermented a bit warm...opinions? on 08-05-2014 at 06:29 PM
Hey guys,A batch of EIPA I brewed this past Sunday was furiously fermenting away last night
and, pressing the palm of my hand against each carboy, I noticed a discernible difference in
Posted in thread: SS braids for hops filters...will they work? on 09-18-2013 at 10:40 PM
Hey guys,Below is a link to a pic of my SS braid system in my MT and I've been thinking lately
that a similar set up in my kettle might help to filter hops, freeing me from having to use a
Posted in thread: Residue from a SS scrubby on 09-16-2013 at 01:53 AM
Hey guys,I used a SS scrub pad as a hop filter wedged under my dip tube and I noticed that a
~1" wide grey film had formed a ring around the hop bag for my hop spider and around the inside
of the kett...
Posted in thread: Height difference required to prime a Chugger pump on 06-03-2013 at 01:47 AM
Yeah, my plan was to have the ball valve on the "out" side slightly open until I see that the
water/wort has gone into the pump, then close it, turn the pump on and then open the ball valve
Posted in thread: Height difference required to prime a Chugger pump on 06-03-2013 at 01:20 AM
Yeah, probably, but not by much.
Posted in thread: Height difference required to prime a Chugger pump on 06-03-2013 at 12:29 AM