Last Activity:11-21-2013 10:10 AM
Posted in thread: NorcalBrewing Solutions Giveaway! on 10-14-2013 at 03:48 PM
Posted in thread: MoreBeer.com Summer Giveaway! on 08-29-2013 at 09:01 PM
Posted in thread: Brewer's Hardware 15 Gallon Stainless Steel Conical Fermenter Giveaway! on 08-01-2013 at 02:16 PM
Posted in thread: StainlessBrewing.com Summer Giveaway! on 06-25-2013 at 01:52 PM
Posted in thread: Kegconnection Giveaway! on 08-15-2012 at 08:12 PM
Posted in thread: Cool Brewing Giveaway! on 05-30-2012 at 01:34 PM
Posted in thread: Grain Mill Motor on 03-12-2012 at 07:01 PM
Should I make it wider or the same width of the pulley. Worried about keeping in balance and
Posted in thread: Grain Mill Motor on 03-12-2012 at 06:32 PM
Okay only issue I have found is that I cannot find a 12" that can go onto the mill shaft that
is 3/8". The motor shaft is 1/2" so no issues there. Anyone know of a way around this?
Posted in thread: Grain Mill Motor on 03-10-2012 at 05:07 AM
Thanks. Do you have a pulley size recommendation to keep the rpms in check of do you think I am
fine with two 3" pulley's?
Posted in thread: Grain Mill Motor on 03-10-2012 at 04:20 AM
I just found a "Brand New" Single-Phase AC Motor in the basement from my Father-in-law ,
honestly it has never been used but it from the 70's. The manufacture is Daytona. I wired it up
and it runs fin...