Last Activity:09-29-2016 1:31 PM
Likes Given: 6
13 Likes on 13 Posts
Posted in thread: Sam's Brew Box on 09-29-2016 at 01:31 PM
Great! That is what I've been looking for. Thanks.
Posted in thread: Sam's Brew Box on 09-28-2016 at 07:20 PM
What receptacle are you using on your incoming power to your control panel? It looked like a
three prong input. Then using a 50amp stove receptacle on the wall?
Posted in thread: Sam's Brew Box on 09-28-2016 at 01:36 PM
Looking good! Do you have a wiring schematic you're using? A 50A 3-wire setup?
Posted in thread: EZboil, Power Regulator for Boiling DSPR110 on 09-23-2016 at 11:55 PM
I currently only have a 3-wire 240v setup so figured the ground could act as a neutral. I have
240v on the other side of the switch when on (120v each side to ground and 240v between the two
Posted in thread: EZboil, Power Regulator for Boiling DSPR110 on 09-20-2016 at 01:44 PM
Yes, I do have a ground to my element. Just forgot to put it on the diagram,
Posted in thread: EZboil, Power Regulator for Boiling DSPR110 on 09-20-2016 at 03:07 AM
What are people here using to produce electrical diagrams? Here is my crude drawing. 370677I
have 120 between A & C but not B & C in boil mode at 100% which makes me think it is the SSR?
On the elemen...
Posted in thread: EZboil, Power Regulator for Boiling DSPR110 on 09-19-2016 at 05:18 AM
I'm having issues getting my DSPR300 working with my SSR (uxcellŽ SSR-40DA-H DC-AC 40A Solid
State Relay 3-32VDC/90-480VAC). I have terminal 6 connected to the negitive (4) of the ssr and
7 to the pos...
Posted in thread: Electric HLT on 09-08-2016 at 04:18 AM
Most electric HLTs have pumps to avoid stratification. With multiple elements you may be able
to place them at varying heights in the tank to help avoid that. Otherwise what ever you use
for a temp se...
Posted in thread: Show us your panel on 09-02-2016 at 01:53 PM
What about if the hinge was on the bottom?Just make sure your wiring lengths are good to your
front panel so when It swings down it doesn't rip any wires loose.
Posted in thread: Moe's 2 vessel brewery on 08-31-2016 at 01:34 PM
Thanks, that was informative. Brew on!