Bean

Gift Premium Subscription To Bean

Join Date:

03-02-2009

Last Activity:

09-25-2016 10:18 PM

Referrals: 1

Likes Given: 11

9 Likes on 8 Posts 

    ABOUT ME

  • Keystone Hops
  • Male
  • Single
  • Philadelphia
  • Pa

LATEST ACTIVITY

  • Posted in thread: Kenmore 12112 Keezer Build on 09-25-2016 at 10:18 PM
    I realized after I uploaded the temp control pics that it's wired incorrectly, the neutral feed
    should be in 5 and not 7 2 & 3 temp probe5 neutral6 hot from source8 jumper from 69 hot to
    compressor

  • Posted in thread: INKBIRD Giveaway at the End of September and Inkbird Super Sale Code on 09-23-2016 at 02:29 PM
    Thanks, InkBird. count me in!

  • Posted in thread: Kenmore 12112 Keezer Build on 09-19-2016 at 11:22 PM
    Where did you get your hinges from?There's an appliance store by me which stores their "white
    waste" outside between pickups. Drove by for a few weeks until I noticed a dead freezer sitting
    there, ran...

  • Posted in thread: Kenmore 12112 Keezer Build on 09-19-2016 at 01:54 AM
    I little tighter than I like for the gas system tubing. I'm planning at pulling the stock
    shutoff valves and adding a 90 elbow

  • Posted in thread: Kenmore 12112 Keezer Build on 09-19-2016 at 01:41 AM
    converted the stock cable to a 90 female IEC 320 C13/C14 Connector. I like doing this because
    it prevents cable strain and also allows the collar to be removed without having to be
    disassemble the ele...

  • Posted in thread: Kenmore 12112 Keezer Build on 09-19-2016 at 01:22 AM
    I use a Love Controls TS3 for temp control. Wiring is simple and pretty painless. It clean with
    the project boxes and there is plenty of room in there still.. I'm considering adding a blower
    system an...

  • Posted in thread: Kenmore 12112 Keezer Build on 09-19-2016 at 01:14 AM
    sadly I lost a bunch of photos when my phone died this week.. but here's where we're at.picked
    up some "bad tint" paint from from the local big box and went to town.. didn't get quite the
    layering aff...

  • Posted in thread: Homebrew setup for sale on 09-05-2016 at 06:52 PM
    can you post some photo's of the conical

  • Posted in thread: Kenmore 12112 Keezer Build on 09-05-2016 at 01:37 PM
    gluing down the enclosures for the electrical connection, I use the project boxes they sell at
    radio shack.

  • Posted in thread: Kenmore 12112 Keezer Build on 08-21-2016 at 04:36 PM
    Any chance of some details and pics on those keg terminals you have installed on the left? I
    have been looking for an easy way to have a "gas out" on my 8 tap keezer and this looks like
    THE BEST optio...

0 COMMENTS
POST A COMMENT