Last Activity:01-20-2017 5:53 PM
Likes Given: 9
14 Likes on 10 Posts
Posted in thread: Why are red wine kits disappointing? on 01-10-2017 at 07:52 PM
Many of the higher cost red kits also have grape skins in addition to the juice. I find it
makes a far superior product that the cheaper kits without the skins...this has been my
experience, I have do...
Posted in thread: HLT/BK in one on 12-28-2016 at 07:23 PM
Would it be a challenge to purge the water before the boil. I haven't worked with pumps yet.Not
sure. I know I would store mine and it never failed there would be water left in it.
Posted in thread: HLT/BK in one on 12-27-2016 at 05:26 PM
Only issue I could think is when you boil in brew kettle mode the water left in the coil will
boil and start spitting at you. I know when I had an immersion chiller it did that.
Posted in thread: Bottom Drain Keggles with Ceramic Insulation Coating on 12-24-2016 at 08:42 PM
Posted in thread: Consistently leaking keg setup... out of ideas. on 12-14-2016 at 07:44 PM
The info here is really good. Some of it new to me... duct tape bowl? Some of it standard
trouble shooting steps that can help out newcomer akin to the experienced . It's a little
frustrating that fin...
Posted in thread: Consistently leaking keg setup... out of ideas. on 12-14-2016 at 06:37 PM
if you are using corny kegs I have had to put a washer under the feet for extra pressure. Also
I was having a similar problem and I started boiling the lids and o-rings before assembling
them and it c...
Posted in thread: Don't Do That. on 12-09-2016 at 04:06 AM
Do not break the stick off of a bottle rocket and throw it under the bathroom door while your
friend is in there pooping.
Posted in thread: Issues with false bottom in beverage cooler on 12-09-2016 at 01:26 AM
Could you fashion a small dip tube down for the False bottom? I was thinking about doing that
Posted in thread: Do I have too much room around my false bottom. on 12-08-2016 at 11:16 PM
Thanks for the quick reply. That makes me feel better. We will know this weekend.
Posted in thread: Do I have too much room around my false bottom. on 12-08-2016 at 10:53 PM
I bought a false bottom cooler conversion. The cooler I have is a gott. Is this too much space
around the outside edge. It's .25 to .50 inch all around gap. 379827