Last Activity:08-26-2016 2:52 PM
Likes Given: 120
108 Likes on 94 Posts
Posted in thread: Unboxing the Nano from CO Brewing on 08-26-2016 at 01:04 PM
I didn't have a hop spider and used some whole hops which quickly clogged the pump. I was
thinking of getting one but didn't know if it would be able to reach the wort effectively since
it was such a ...
Posted in thread: Unboxing the Nano from CO Brewing on 08-24-2016 at 08:59 PM
Yes, I do all my calcs on the puter typically then save to the cloud and copy back to my phone
just before brewing. I have actually built most of recipe in my phone before but theres some
things you c...
Posted in thread: Unboxing the Nano from CO Brewing on 08-24-2016 at 08:18 PM
I need to get my laptop running so I can use the full BS potential. The app is limited. Getting
really close to brewing and have yet to mess with calibration or setup parameters
Posted in thread: Colorado brewing systems on 08-18-2016 at 06:29 PM
There need to be a threaded boss in the basket and the kettle to hold it in place better. I'll
figure something out over time and use
Posted in thread: Colorado brewing systems on 08-18-2016 at 12:57 PM
Ordering my last bits of TC parts, get the GFCI wired and I will be doing a wet run to
calibrate the temp probes (I am adding a probe to my CFC chiller) and it's ready to go. Anyone
have a solution to...
Posted in thread: Unboxing the Nano from CO Brewing on 08-05-2016 at 07:26 PM
When I was running my chugger I would have probably opted for the three way eventually. Now
though I don't think its necessary with the way the pump is attached directly at the output.
After I pump to...
Posted in thread: Unboxing the Nano from CO Brewing on 08-05-2016 at 02:27 PM
I do wish I had a drain in the floor directly beneath mine, there is one in the room but water
does not flow to it naturally.Yeah for now it will be drip trays and a hose directly to the
drain when ch...
Posted in thread: Unboxing the Nano from CO Brewing on 08-05-2016 at 12:48 PM
FINALLY getting moved into my house. Need to run power, GFCI, vent, water (all existing PEX
thank god), order some misc tri-clamp pieces and I should be good to go. Over the winter I may
get crazy and...
Posted in thread: Beer Line Cleaning Question on 07-20-2016 at 08:00 PM
Get a few of these and daisy chain your ball lock and then run 1/2" tubing from faucet to
faucet. Open faucets and get a cheap pond pump and recirculate your cleaner of choice. By far
the easiest way ...
Posted in thread: Tap covers/plugs for Perlick faucets? on 07-15-2016 at 04:16 PM
Had these on my 525's with no issues, they do fall of my 630's now and it's a bit frustrating.
Now I need to buy the internal plug style.