Originally Posted by HansEinar
When I download picprog.ino from work branch the file show:
* buffer. If you should use another software that does not have this feature you may
* need to lower the baudrate significantly.
/* Define STC-1000+ version number (XYY, X=major, YY=minor) and EEROM revision */
#define STC1000PI_MAGIC_F 0x196E
#define STC1000PI_MAGIC_C 0x2691
#define STC1000PI_VERSION 100
#define STC1000PI_EEPROM_VERSION 10
But after flashing and doublepress the STC show 1.06 in display.. and the simulate html has other settings. Am I on wrong file?
Redo, and remember each required step. Download, open in Arduino IDE, check corrwct board and com port, upload to arduino
, open serial monitor, press 'd' (check version of sketch) and finally flash the STC.