I'm almost complete with my build, but have a question on the gas plumbing..
Just as a visual it's a brutus type clone with no gas tube. I was going to run exterior gas plumbing.
Why is everyone using 1/2" Black pipe and not 3/8"??
I used 1/4" for my whole gas system. I guess you can use larger if you want, but I had trouble getting the pressure I needed for twin 10" banjo burners with larger pipe.
I plan on using 1/2" black pipe simply because that's what home depot carries.
Are you using an electric valve to open and close your burners?
What valves are those??
Also what did you use as pilots??
Thanks for your help
I too am planning to run exterior gas plumbing on my build so keep the updates coming!!
I always thought you were suppose to match your current plumbing your splicing into is. But then again, I have not pulled the trigger on this conversion yet.