Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   DIY Projects (http://www.homebrewtalk.com/f51/)
-   -   Screwed up my Mash Tun (http://www.homebrewtalk.com/f51/screwed-up-my-mash-tun-138122/)

1234 09-23-2009 03:11 PM

Screwed up my Mash Tun
 
Hey guys I could use some help. I traded a keggle for rubber coated keg that I planned to use as my mash tun. When I went to drill the pilot hole I realized I was a little low so I moved my bit just a bit higher thinking that it would round out into the initial pilot hole. Now I have a hole that has a extra little taken out of the bottom, can you help. I would post a picture but I am not sure how. If I figure it out I will post a picture. :(

IrregularPulse 09-23-2009 03:13 PM

JB welt to patch it then reshape the hole. No welding required. Or if it's through rubber, use hightemp silcone.

samc 09-23-2009 03:45 PM

Depending on how much extra opening you created it might be simpler to buy a larger silicone o-ring and SS washer to cover the over sized hole.


All times are GMT. The time now is 04:09 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.