Grr... I've searched and I know I saw pics last summer of one that someone made, and for the life of me I can't find em... It was a square base, with the main jet tube that tha carboy slid down over. Whole unit sat on the ground. Anyone have any ideas? I always thought it was a good DIY idea, but I'm not finding it anywhere...
Anyone?
Bueller?
Ize
__________________
"They who drink beer will think beer"
-Washington Irving
Sig to re-open when it's less of an embarassment
What I do for a living on the web... www.wsoyam.com
__________________ On Tap: Lake Walk Pale Ale -- Eternity (Raspberry Stout) -- Nutrocker -- Donnybrook Dark Primary: Lake Walk Pale Ale Secondary: Summit IPA Up Next: Smoked Porter -- Pub Ale -- Watermelon Wheat Planning: Gone But Not Forgotten:
I've seen another one too, but I can't remember where.
__________________ On Tap: Lake Walk Pale Ale -- Eternity (Raspberry Stout) -- Nutrocker -- Donnybrook Dark Primary: Lake Walk Pale Ale Secondary: Summit IPA Up Next: Smoked Porter -- Pub Ale -- Watermelon Wheat Planning: Gone But Not Forgotten:
__________________ On Tap: Lake Walk Pale Ale -- Eternity (Raspberry Stout) -- Nutrocker -- Donnybrook Dark Primary: Lake Walk Pale Ale Secondary: Summit IPA Up Next: Smoked Porter -- Pub Ale -- Watermelon Wheat Planning: Gone But Not Forgotten:
That's a small deck I built on the front of the brewshed so I can wash equipment. Since that picture I have aquired a utilty sink that sets where the workmate is. Next is a small hot water tank, the water get quite cold this time of year.
__________________
Do you ever see a motorcycle in front of Therapist's Office??? Insert Name Here Brew Club
i just made one for appartment dwelling. Only difference is mine attaches the pipe your shower head would attach to. I also included an extra T piece with a screw in plug so after i run it and get the crud out I can stop the water, added some detergent in the T, the start the water again and run some soapy water through which then turns to water to rinse it away. EVERYONE! with glass carboys should make this. I dropped my 6.5 glass carboy 2 inches and it scared the sh!t out of me (luckly it didnt break). Next day I built one for $20 and in 5 min with a drill and hack saw. I use to fill it with water, shake it, dump and repeat. This was back breaking, risky and time consuming. Using this it was 5 min, easy and much safer. Do yourself a favor and invest $10-20 on this.