Ss Brewing Technologies Giveaway!

Home Brew Forums > Home Brewing Beer > DIY Projects > Orifice size with SQ 14

Reply
 
LinkBack Thread Tools
Old 12-13-2012, 06:01 PM   #1
britebeer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Apr 2012
Location: arkansas, Arkansas
Posts: 9
Default Orifice size with Bayou Classic SQ 14

So I just purchased a new Bayou Classic SQ 14 and used it for the 1st time last weekend. The 55000 btu burner seemed quite a bit slower at heating my 150ish wort to a boil than my older eastman outdoors 68000 btu burner both on a 10 psi propane regulator. I do realize that there is a 13000 btu difference but still it seems like it should be faster.

I would like to drill out the orifice in order to increase the BTUs. It seems as though with the air shutter all the way open and the regulator open a little past half way it blows out the flame. Am I wrong to believe that this is coming from the burner running too lean at this point and that if I increase the orifice size it will not only slow down the air intake but also increase the fuel output and therefore allow me to run the regulator open wider with the air shutter all the way open?

So my next question would be.. what is a good starting point with the SQ14 at 10 psi propane to try and widen the orifice?

And.. is there a way to replace the orifice on the stock 10psi regulator stainless hose that comes with the SQ14 if I screw it up?

__________________
britebeer is offline
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Drill bit orifice size Nightbrew DIY Projects 20 08-15-2013 04:00 PM
Where can I get an orifice Bullet DIY Projects 12 08-21-2012 10:46 PM
Bayou Classic BG10 and BG12 Orifice THREAD Size dutchoven DIY Projects 7 02-24-2012 08:10 PM
What orifice size for BG-14 burners? ghart999 DIY Projects 0 03-28-2011 03:21 PM
Jet burner orifice size? cgondoli1 DIY Projects 5 01-17-2011 12:42 AM