New Giveaway - Wort Monster Conical Fermenter!

Home Brew Forums > Home Brewing Beer > DIY Projects > newbie here...freezer to fridge convert




Reply
 
LinkBack Thread Tools Display Modes
Old 03-12-2009, 01:50 AM   #1
bctdi
Feedback Score: 0 reviews
Recipes 
 
Join Date: Mar 2009
Location: N.W. Atlanta Metro,GA
Posts: 230
Liked 8 Times on 7 Posts
Likes Given: 2

Default newbie here...freezer to fridge convert

Stumbled upon this procedure today on the net and was wondering if anyone has tried this.here is the copy/pasted procedure... using the original mechanical thermostat cold control switch that came with the freezer!

Some newer units may have digital thermostats and the info below won't apply.

Most mechanical cold control switches have a small calibration set screw beneath the temperature control dial knob(usu. requires removing the dial knob to access the set screw). Adjusting the set screw changes the nominal set point temperature of the thermostat.

Here's the procedure to recalibrate the freezer to operate as a fridge:
1) Plug in. Compressor should turn on and begin cooling the chest.
2) Set the temp dial at the middle setting.
3) Place remote probe of dual-temp indoor/outdoor thermometer inside the fridge.
4) Remove the dial knob (pull directly out from the control switch).
5) When chest reaches your max desired operational temp (e.g. 43 deg F), turn the set screw clockwise until the compressor shuts off. Count turns carefully so you can return to original calibration if this fix doesn't work (best to mark a line on your screw driver to keep count of the turns). My switch required about 6 1/2 turns.
6)Open the chest door so that it will warm up relatively quickly.
7)Monitor the max temperature reached when the compressor comes back on.
8)Close the door and monitor the the low temp at which the compressor shuts off.
9)Repeat 6-8 a few times to verify repeatability. If the temperature differential between the min and max is around 5 deg F as it was in my case, means that your freezer is now working at refrigerator temps at your new set point, e.g. 40degF +/- 2.5degF. If the differential is too large, i.e. greater than 10degF, this fix won't work and you'll have to return the set screw to the original calibration setting and try something different like a brewers thermostat that over-rides the existing thermostat.
9)Reattach the dial knob and fine-tune set point with the control knob as desired.



__________________
bctdi is offline
 
Reply With Quote Quick reply to this message
Old 03-12-2009, 06:26 PM   #2
McKBrew
Feedback Score: 0 reviews
 
McKBrew's Avatar
Recipes 
 
Join Date: Oct 2006
Location: Silverdale, Washington
Posts: 8,292
Liked 29 Times on 26 Posts
Likes Given: 8

Default

I've never heard of it, but it might work.

Personally, spending the 50 bucks on a controller is probably a bit easier and guaranteed.

__________________
McKBrew is offline
 
Reply With Quote Quick reply to this message
Old 03-13-2009, 11:38 PM   #3
bendavanza
Feedback Score: 0 reviews
Recipes 
 
Join Date: Aug 2008
Location: Oak CLiff, TX
Posts: 2,348
Liked 13 Times on 13 Posts
Likes Given: 2

Default

I've heard of this trick to make cheap kegerators get DOWN to the temps wanted when the coldest setting wasn't cutting it. This may be a free fix for keezers as well, I guess it depends on how yours is built.

__________________
bendavanza is offline
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options
Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Best way to convert this new Freezer I found stevenryals DIY Projects 2 03-04-2009 04:47 PM
how to convert an old fridge? bkov Bottling/Kegging 1 01-20-2009 12:09 AM
Can I Convert this Danby Fridge? jayhoz Bottling/Kegging 4 04-12-2007 02:18 PM
Can I convert a small fridge w/ a freezer shelf? Mr. Mojo Rising Equipment/Sanitation 14 04-11-2007 01:49 AM
convert box freezer for lagering? megavites Equipment/Sanitation 5 03-18-2007 12:42 AM