Originally Posted by n2fooz
For mounting the burners, I used the heat shields. I drilled holes for the supplied burner screws at the bottom of the shield and mounted the burner to the shield. I then drilled and tapped (4) 10-32 holes on the 45º gussets. The burner/heat shield assembly is then mounted to the stand with (4) 10-32 stainless steel cap screws and washers.
Hope this helped.
Ok, thanks for the pic, your captions made things incredibly easy.
Also, are you using converted kegs or kettles? A couple discreetly drilled holes in the lower keg skirt could give the gas some place to go if you are going the keggle route. Thanks for providing the dimensions and cut sheet also, very helpful to those of us in the planning phase