Its all painted ignore the zip ties holding the gas manifold on they are going to be replaced once i get some 1/2 inch pipe straps.
I hooked it upto an old regulator from a rusted out burner its only 10 psi and both burners crank out blue flames a good 8 inches high. I just have to get a new hose for it as the swivel connection at the manifold end leaks. Then the final step is to get the pump once i get some more funds.
While waiting on pumps to get back in stock so i can order one i have been contemplating how i want to plumb it in. I was leaning towards using 1/2 inch rigid copper to hard plumb most of the lines and using barb fittings and 1/2 inch thermoplastic tubing to make short connections to the pot and mashtun. Any other negatives to using copper other then it not being flexible?