HI_SALENITY

Recipes 

What size should I drill the holes in the manifold of my cooler mash ton ?
I am thinking of 1/8'' but I wanted to make sure that was not to big or to small.

This is what I have so far, it is Pex.

EO74

Recipes 

I used a ss braibed sleave from a cut flexible water line but if there on the bottom i think u can go bigger or cut straight slots the width of like a sawzall or hacksaw blade.I tried it before i got the braided line good luck i didnt have the patience for all those cuts!

Beernik

Recipes 

I did horizontal cuts with a circular saw. I'm guessing they are about 1/8" wide.

I'd also put two more cross bars on the manifold to shorten the distance the wort has to travel to reach a hole (reduces the the risk of short circuiting of your sparge water).

oceanselv

Recipes 

I used an ordinary hack saw blade cutting the holes every inch or so apart.

__________________
Please help me raise money to help find a cure for children's cancer. I am shaving what is left of my hair at an upcoming St. Baldrick's event. Please donate here http://www.stbaldricks.org/participants/mypage/participantid/433395

_______________________________________________

Primary1: German Pils, Kolsch
Secondary:
On Tap: Chocolate Stout, Amber Ale