Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   DIY Projects (http://www.homebrewtalk.com/f51/)
-   -   keggle stand with diy natural gas burner (http://www.homebrewtalk.com/f51/keggle-stand-diy-natural-gas-burner-102433/)

Highlandsbrew 02-09-2009 01:42 AM

keggle stand with diy natural gas burner
 
2 Attachment(s)
I just finished my brewing stand for my keggle, it is nothing like some I have seen on here, but it works for now.

Jaybird 02-09-2009 02:30 AM

That is one hell of a burner you got there! Cool DIY. Good job

The Pol 02-09-2009 03:40 AM

That is a freaking blow torch... sweet...

Bobby_M 02-09-2009 02:26 PM

Very nice. How do you rate the adjustability of the flame? Have you done any tests and estimated your BTU?

sjlammer 02-09-2009 04:47 PM

Do you have a parts list. I can't see from the pictures how that is made.

Anthony_Lopez 02-09-2009 05:02 PM

what the hell kinda burner is that?!

Bobby_M 02-09-2009 06:08 PM

It's a "jet" burner which is really just a generic term for a wide open mix pipe. Any burner design requires that the injection of the fuel is able to pull in air that it will mix with prior to being ignited. This one seems to shoot the fuel past an adjustable opening, it mixes with the air in the large tube and then burns on the way out. I've also seen a similar design that has a small circular plate of metal mounted about an inch above the opening so as to diffuse the flame into a circle instead of a point.

Looks like this: http://www.target.com/Bayou-Classic-Burner-Flame-Spreader/dp/B0002913MI

wildwest450 02-09-2009 06:27 PM

Is it noisy??

caver95 02-09-2009 06:31 PM

I have one for my forge that is about the same as a turkey fryer.
Propane Forge Burner Design / Sidearm Burners
Its propane, not NG

Highlandsbrew 02-09-2009 06:55 PM

Mine is similar to the one in caver95's post, but I am using a orifice out of a natural gas burner from a furnace that is on the end of a 1/8"X4" nipple that I can adjust up or down in the burner tube. I have not calculated the btu output yet, but It does sound like a jet engine when I run it full open. The bottom T fitting is 1-1/2 and the burner tube is a 1"X12" pipe nipple with the threads cut off the top. Here is a link to a drawing of one that is similar.http://www.abana.org/ronreil/Sidearm.jpg


All times are GMT. The time now is 06:18 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.