Originally Posted by LandoLincoln
So...a stainless hex plug plus a couple of stainless washers, a silicon washer and a locknut? That's all that would be needed?
So you'd put the hex plug and a stainless washer on the outside, and on the inside you'd have the silicon washer, then a stainless washer, then the locknut?
I'd very much like the hex part of the plug to have enough surface area to support the gasket directly, but I think I'd put the plug into the hole from outside then gasket and locknut inside. Basically you'd be duplicating how the thermometers are done but with a plug instead.
Sightglass, Refractometer, Ball Valve, Weldless bulkhead, Thermometer, Decals, Stainless Steel Fittings, Compression Fittings, Camlock Quick Disconnects, Scale, RIMS tube, Plate Chiller, Chugger Pump, Super Clear Silicone Tubing, and more!New Stuff?