Originally Posted by Happydaze187
I just centered the tower and came up 6" from the back and started cutting from the inside with a box knife. The inside skin was easy to cut then there was an aluminum or tin skin that was a bit harder to get through but once I had a small hole in it I just tore it out, to find the lines I just dug out the foam insulation out by hand. I was able to center 2 of the coolant lines inside and the top line seemed to be a return line best guess. The top metal I just pierced a small hole through from the inside and then started cutting with some side cutters. Best of luck to you! Just take it slow...
Sent from my SCH-I545 using Home Brew mobile app
Thanks man. I'll take it slow and just figure it out as I go along. BTW I have the same setup as you. Same tank, regulator, hosing, etc.... Bevfactory special! Works well too.
Camp Brew Co.
"If you've heard this story before, don't stop me, because I'd like to hear it again."
Kegged: Stony Man Pale
Bottled: Bourbon Oak Brolic Strong ale
Primary: Hill 56 clone
On Deck: Ava ale, Red Ryes ale, Priceless Pup Brown,