Newest Threads

cgondoli1 · 01-15-2011, 04:07 AM

Can someone with a low pressure 10 tip jet burner please tell me what the orifice size is? I have a 44 tip high pressure burner and im planning to make three small burners and run on low pressure. Thanks

cgondoli1 · 01-16-2011, 03:42 PM

Anyone have one that could help me out??

**P-J** · 01-16-2011, 04:56 PM

You did not say which gas you were going to be using:

The burner is an impinging jet design. The natural gas burner has an orifice that is a #56 wire drill gage size. If it has one, the pilot jet has the same size orifice.

The propane burner of the same design has jets that are #75 wire drill gage size. The pilot jet is also the same size.

Hope this helps.

BTW - this is from measurements that I took from my burners way back in January of 2007. I had to dig up the info from when I had posted it in another forum.

cgondoli1 · 01-16-2011, 11:56 PM

Thank you so much, i want to keep it propane just use low pressure. is that the size for lp lp?

**P-J** · 01-17-2011, 12:03 AM

Quote:

Originally Posted by cgondoli1

Thank you so much, i want to keep it propane just use low pressure. is that the size for lp lp?

That is the correct size for low pressure propane. #75 wire drill gage.

cgondoli1 · 01-17-2011, 12:42 AM

Thanks! tomorrow i can get to drillin!