Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   DIY Projects (http://www.homebrewtalk.com/f51/)
-   -   Dimple Megapot 1" and 1.5" (http://www.homebrewtalk.com/f51/dimple-megapot-1-1-5-a-385745/)

kickflip_mj 01-30-2013 12:47 AM

Dimple Megapot 1" and 1.5"
 
First is it possible? Im looking to weld 1" and 1.5" triclovers onto a 25 gal megapot from Northernbrewer. I just dont want to tear the side of the pot.

StMarcos 01-30-2013 05:59 AM

Of course. Why wouldn't it be possible?

kickflip_mj 01-30-2013 04:40 PM

I guess my concern is to rip the pot because of the thickness. What size hole would you recommend before I pull a 1" and 1.5"?

StMarcos 01-30-2013 10:07 PM

Hole size to match the id of the tc ferrule. If your welding, what is this about dimpling?

kickflip_mj 01-31-2013 04:58 PM

well im pulling a tc from the inside, and welding a tc to the otherside outside the kettle. Its just much easier to weld them together and guarantee and sanitary fitting. I have done it on a keggle no with problems. Just on a thicker megapot it concerns me.

kickflip_mj 02-01-2013 12:53 AM

bump

thelorax121 02-01-2013 01:59 AM

It should be fine. I can't imagine the megapots are any thicker than sanke kegs (did not fact check this), but it has been successfully done on those, take a peek at the soldering stainless thread

captainoverspray 02-01-2013 05:07 AM

purge it with argon on the inside and make sure you have good penetration if you are tig welding. You should have nothing to worry about.


All times are GMT. The time now is 03:23 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.