I am currently moving a single BG10 burner with a 10psi regulator back and forth (HLT <-> BK) as needed during my brew day. This for obvious reasons is getting old.
Planning on building a proper direct fired RIMS brewstand using 2 more of the same burners.
How much more regulator do I need?
I plan on hard piping the burners (each with its own control valve) and don't expect to have more than 2 burners lit at any one time. (I think)
The current setup gets to a boil reasonably quick at full on 10PSI regulator. The burner spec says that it can be driven with a 20psi reg for more BTUs. This makes sense for HLT and BK, not necessarily for the recirc'd MLT. (No need for you electric guys to chime in here )
Any advice on this is welcome! Pics of your similar setup would be nice as well.