Originally Posted by Peter_h
Free shipping to Hawaii too?
You bet! This is for ALL HBT users in the USA with orders over $80 that have a fasle bottom in the order. PM sent
Originally Posted by cwheel
Can I get the promo code also? Thanks!
By the way, I have a 12" round 32 quart kettle that I use as my boil kettle. I plan to order a 12" false bottom, and probably make a stand and drill the hole to my exact specs. But right now, I have a typical kettle valve with kettle screen installed, and the CENTER of that system is about 1.5" above the bottom of my flat bottom kettle. Assuming I position the false bottom so that it is about 3/4" above the bottom of my kettle, is the remaining 1/2" to 3/4" above that false bottom enough to get one of your dip tubes to bend down into the hole in the false bottom? Does that make sense?
I guess basically what I'm asking is how much room do you need to make that 90 degree elbow down in your dip tube? Can the center of dip tube to bottom of diptube opening be about 1" to 1-1/4", or is that too short?
I only ask this because I've been using this system for a while and the hole in the kettle has already been drilled. Thanks!
That is a real tight bend for me.. I need 2.25" for a full 90 deg bend.
Just a thought though, why not make the stand tall enough to go "above" the drain and have the diptube under the false bottom? then we can make the diptube any size you need and it doesent have to be a full 90 deg bend?
Thanks a bunch for everyone that has ordered so far!