Happy HolidaySs Giveaway - Winners Re-Re-Re-Re-Drawn - 24 hours to Claim!

Get your HBT Growlers, Shirts and Membership before the Rush!


Home Brew Forums > Home Brewing Beer > Extract Brewing > Specialty grain steeping question
Reply
 
LinkBack Thread Tools
Old 09-29-2012, 01:41 AM   #1
brewkinger
HBT_LIFETIMESUPPORTER.png
Feedback Score: 0 reviews
 
brewkinger's Avatar
Recipes 
 
Join Date: Sep 2012
Location: East Podunck, Vermont
Posts: 1,673
Liked 199 Times on 165 Posts
Likes Given: 229

Default Specialty grain steeping question

I was reading through a thread earlier under the Beginners forum and I came across an old thread that covered basic extract brewing guidelines.

There was a couple of points in it that focused on steeping the grains and I want to make sure that I understood it correctly.
The thread starter/moderator of sorts discussed steeping the bag of grains in a SMALL amount of water (his method was 1-3L of water per pound of grains.

So if the batch I made last week that included 1 lb of specialty grains, would/should have been steeped in just under 1 gallon of water?
Under 165 degrees or 20-30 minutes?

Am I understanding this correctly?

Then what? Add rest of boil volume water (in my case 2.5 to 3 gallon partial boil)

Proceed with extract addition, etc...

Thanks

__________________
Blackbird Brewing

PRIMARY:
SECONDARY- Apple Cider (13 gallons)
CONDITIONING:
DRINKING: Hill Farmstead - my local brewery
DRINKING: Mish-Mash/End of Summer Ale
PLANNING: Dunny's Learn To Homebrew Day APA
Do not mistake my kindness for weakness. I am kind to everyone, but when someone is unkind to me, weak is not what you will remember about me.
brewkinger is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 03:19 AM   #2
HerbieHowells
Feedback Score: 0 reviews
Recipes 
 
Join Date: Oct 2011
Location: Denver, CO
Posts: 376
Liked 37 Times on 35 Posts
Likes Given: 2

Default

That is correct. I believe that some people believe you can get an astringent flavor from steeping in too much water. That temperature and time are perfect. You don't want to boil grain, or really let it get into the 170s or above.

While looking into my brewing water use, I stumbled upon some advice for steeping that I applied to my next brew. It has been cut and paste a few times, so I will go ahead and post it here. Original credit to user Saccharomyces:

Quote:
I was talking with Chris Colby (BYO editor) a few months back about his method for extract/steeping grains. We were discussing your very problem which is very common -- 99% of brewers will get to the level where you are now with extract/steeping grains and think they have to go to AG to make better beer. Fact is you don't, Chris only does AG batches with a brew buddy. He has been doing extract for 20 years and he makes some GREAT beers. Here's the Colby method:

- Start with 1 gallon of Campden treated RO water and 1 tsp of 5.2 pH stabilizer in the kettle. Stir in 1 lb of dry extract while heating to 165*F. At 165*F remove from heat. Drop in the steeping grain bag, tea bag it to get the grains wet and let it sit 30 minutes. Steeping in a small volume with pH stabilizer and extract keeps the pH around 5.2 which will prevent extracting tannins from the grain husks, which is the most common off flavor in extract beers.
- Drop a strainer over the pot and move the grain bag to the strainer. Run your top-off water slowly over the grains to rinse them until you get to your desired boil volume. Stir in 1/3 of the remaining extract for a partial boil, or 2/3 if doing a full volume boil, and bring to a boil. Add your bittering hops.
- With 15 minutes left in the boil, add a whirlfloc tablet, yeast nutrient, and the rest of your extract (do this off the heat so you don't scorch of course!).
- Stir continuously while chilling until the wort drops below 140*F. Chris uses an immersion chiller in his sink and then moves to an ice bath until he gets down to pitching temp. I already gave you my method, while more hands-on it works too.

Give his method a try and I think you'll be amazed at the results.
If you didn't do all that, you will probably still be fine. Consider it a control batch before trying the Colby method.
__________________
HerbieHowells is offline
2
People Like This 
Reply With Quote Quick reply to this message
Reply



Quick Reply
Message:
Options
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Method for Steeping Specialty Grain tjashing Extract Brewing 24 07-13-2012 05:56 PM
Specialty Grain Steeping (Quick Help please?) FatBaldBeerGuy Extract Brewing 8 03-29-2012 12:28 AM
Question on Steeping Specialty Grains - not volume brtisbuck Extract Brewing 12 01-26-2012 02:54 PM
Steeping Specialty Grains Question barkscruff Extract Brewing 9 10-25-2011 09:01 PM
Specialty Grain Steeping Question Heavyfoot Extract Brewing 4 12-08-2010 12:50 AM



Newest Threads

LATEST SPONSOR DEALS