Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   All Grain & Partial Mash Brewing (http://www.homebrewtalk.com/f36/)
-   -   Keep getting a low gravity (http://www.homebrewtalk.com/f36/keep-getting-low-gravity-300169/)

kriznis 02-01-2012 02:18 PM

Keep getting a low gravity
 
Brewed my 2nd all grain batch last weekend & the o.g came out low again. What could be causing this? I'm following the directions on the recipe exactly

jaycount 02-01-2012 02:38 PM

Could be alot of things causing low extract efficiency. Tell us all about your system and process. BIAB? Batch/fly sparge? Do you mashout? How hot is your sparge water? Are you boiling off less than the recipe calls for? How far short of the OG are you coming up??

TarheelBrew13 02-01-2012 04:47 PM

When I first went to all-grain, I had the same problem. I would always hit below my estimated pre-boil gravity. For me, it turned out to be dough balls. I had no idea how much you had to beat the grain to get rid of dough balls and Beersmith doesn't give you that info in the directions. If you are using a brewing software, and everything else is going according to plan, I would start with making absolutely sure there aren't any dough balls when mashing in.

My process is to add my strike water to my mash tun. Then in three equal additions, I add my grain, mixing the grain into the water thoroughly before adding the next addition. This has fixed my problem. I used to heat my strike water a couple of extra degrees over what my software suggested to make sure I had plenty of time to mix in the grain but now that I'm better at it I don't do this.

If you are confident that you aren't getting dough balls, I would look at your crush size. A course crush will kill your OG. Lastly, if these two things aren't a problem I would check your mash tun setup. If your setup is really inefficient, you could be leaving a lot of good wort at the bottom of your mash tun. But this is much less likely the cause of your problem.


All times are GMT. The time now is 04:27 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.