Ss Brewing Technologies Giveaway!

Home Brew Forums > Home Brewing Beer > All Grain & Partial Mash Brewing > anyone have a design for bulkhead and RIMS going into a cooler lid?
LinkBack Thread Tools
Old 04-22-2014, 02:15 AM   #1
Feedback Score: 0 reviews
Join Date: Jul 2010
Location: Tucson
Posts: 410
Liked 3 Times on 3 Posts

Default anyone have a design for bulkhead and RIMS going into a cooler lid?

I have a two-vessel system with a single pump, recirculating mash but have no way to maintain temperature thus far. I was thinking of punching a hole in my 10-gallon cooler lid and running a bulkhead through to allow a camlock connection to my hoses. Then it occured to be to add a simple 120V RIMS tube line so I could add a little bit of heat before returning through the lid bulkhead.

Surely someone else had done something similar before. Are there any design threads on HBT I can read through?

twd000 is offline
Reply With Quote Quick reply to this message

Quick Reply
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Diy cooler bulkhead clarksc4 General Beer Discussion 3 12-21-2013 03:55 AM
The No-Leak MLT bulkhead design Bobby_M Equipment/Sanitation 93 07-29-2013 11:45 PM
New bulkhead fitting design StainlessBrewing DIY Projects 20 07-06-2012 05:49 PM
yet another bulkhead design (with pics) paledragon Equipment/Sanitation 4 02-08-2012 03:35 PM
Cooler Bulkhead...?? Jester Equipment/Sanitation 12 08-20-2007 01:41 AM