NoVa

Recipes 

I've been searching and I can't find a thread for answer to my question. I recently pieced together a 4 keg system with secondary regulators, but I'm not sure what PSI my primary regulator needs to be set at to adequately support all the kegs. Say 12+12+12+12= 48PSI for primary or do I need to do something differently?

Thanks

Dr_Deathweed

Recipes 

If your regulators are hooked up in-line on the high pressure port, you shouldn't have to worry about what your first regulator is set too.

My $0.02, if some one knows more about these systems feel free to chime in.

__________________
"Never ascribe to malice that which can be adequately explained by incompetence." - Napoleon Bonaparte
“An intelligent man is sometimes forced to be drunk to spend time with his fools.” - Ernest Hemingway

Fermentation Cabinet●Adding Faucets to a Tower●DIY Hopback●Portable Kegerator

bendavanza

Recipes 

You shouldn't need more than 12 at the primary if your secondaries are at 12, but since you probably have check valves and such which can create resistance, I'd set the primary higher than the highest secondary setting you will use. 20 psi should be fine. 48 would be fine, too.