Kegconnection Complete Starter Kit and More Giveaway!


Home Brew Forums > Home Brewing Beer > Bottling/Kegging > O-Rings

Reply
 
LinkBack Thread Tools
Old 04-03-2010, 07:23 PM   #1
Boomer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Mar 2010
Location: Palmer, AK
Posts: 216
Liked 2 Times on 2 Posts

Default O-Rings

If you've been following any of my other threads, I've gotten enough equipment to make a kegerator. I got 3 corny kegs at my LHBS and a new set of O Rings for each of them. I don't know how to change them or how often it needs to be done. Could someone help me out here?

Thanks.

__________________
Ducks & Dogs Brewery
Primary: Double Wheat Orange IPA
Secondary: Air
On Deck: Probably a SMaSH with M.O. and Citra
Bottled: Fugged Up Irish Stout
Boomer is offline
 
Reply With Quote Quick reply to this message
Old 04-03-2010, 09:17 PM   #2
Ohio-Ed
HBT_LIFETIMESUPPORTER.png
Feedback Score: 0 reviews
 
Ohio-Ed's Avatar
Recipes 
 
Join Date: Nov 2008
Posts: 2,072
Liked 18 Times on 17 Posts

Default

You should have gotten 5 o-rings in 3 sizes.

The large o-ring goes on the lid, just peel off the old one and replace with the new, it should seal the lid to the keg.

The next middle size is the post o-rings (should be 2). They fit into the groove on the liquid and gas posts on the keg. The old ones can be kinda hard to get out because they are tight... you can pry em out with a very small screwdriver or if needed you could even cut them. The new ones are not hard to put back on.

The smallest o-rings are the dip tube rings. You have to remove the posts to replace them. The posts (gas and liquid) are threaded onto the keg. With a socket you should be able to remove the posts (at first glance they look the same, THEY ARE DIFFERENT, keep straight where they go back on the keg). Under the posts, you'll see the top of the dip tubes. Once the posts are removed, you can remove the dip tubes by pulling up or pushing from inside the keg (make sure you keep the posts and the tubes together and attached to the correct side of the keg). The short tube is the gas tube, the long one is the liquid out tube.
The dip tube o-rings then just slide off the tubes and the new ones slide right back on.

I suggest you get and use "keg lube" to lubricate the new o-rings to help keep them soft and seal up.

The post o-rings are the ones that take the most abuse, but I would think you should get at least half a dozen uses or more (I've never had one that I knew had to be replaced).

__________________
Ohio-Ed is offline
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
o-rings motobrewer Bottling/Kegging 2 01-14-2010 02:50 PM
O Rings Cactus Bottling/Kegging 12 03-03-2009 12:20 AM
O-rings ModlrMike Equipment/Sanitation 4 12-13-2007 03:04 AM
O rings. Orfy DIY Projects 7 03-30-2007 04:32 PM
Keg O-rings. AHammer16 Bottling/Kegging 6 02-09-2006 05:34 PM