So I'm building a keezer, and I had my (3) kegs and CO2 set up delivered yesterday. (Got all of it from kegconnection.com, they're great and giving them a plug here) Everything goes together fine with the exception on the liquid out post on one of the kegs. All (3) of the liquid out disconnects that were sent to me won't fit on the post.
They all fit perfectly on the other two kegs, so I know it's not the disconnects. It also is NOT a gas post on this keg either. No notches, and the gas disconnects wont fit on it either, so I suspect I have a warped or bad post or something. But before I go about securing a new post, I figured I'd ask the infinite wisdom of HBT for what else could possibly be causing my problem.
So, any ideas?
PS The disconnect fits over the O-Ring perfectly but when it gets to the flared part of the post, it gets stuck and won't seat properly. Like I said, no problem like this on the other 2 kegs, and the gas disconnects won't fit either.