Can't seam to get the ball valve to stay put. When you open and close it it's fine but it's loose and spins around. There is also a little leakage as well. Not sure what I did wrong can you guys help me trouble shoot?
this is for batch sparging. I'm using 1/2 inch brass ball valve and stainless washers on the inside. I have an O ring on there as well.
watch the video so you see what I mean.
In that pic there is a brass pipe about 2 1/2 inches long
connecting the bazooka screen is a brass coupling
A brass compression coupling for the front of the ball valve
I ended up using 3 zinc washers for the outside of the cooler and 2 stainless washers not shown in photo for the inside.
I also used a rubber washer for the outside as well.