Press the up arrow once to show the current SET TEMP
Press the down arrow once to show the temperature DIFFERENCE VALUE
To enter PROGRAMMING MODE press and hold the S key for 3 seconds.
The display will change to F1 and a light will appear under the word Set on the controller.
Use the arrow keys to choose which function you would like to change. Press the S key to make your selection.
F1 = SET TEMP
F2 = DIFFERENCE VALUE (variance from the set temp
F3 = COMPRESSOR DELAY (in minutes)
F4 = PROBE ERROR CORRECTION (positive or negative by 0.1 degree)
While holding the S key down, press/hold the arrow keys to adjust the value. When you have set the value you want release the S key and the arrow key.
If you press the arrow key without holding the S button down you will be able to make changes to another function if necessary.
Press the POWER BUTTON (above the S key) to save your changes.