Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   Other (http://www.homebrewtalk.com/f256/)
-   -   Grain Mill motor wiring help? (http://www.homebrewtalk.com/f256/grain-mill-motor-wiring-help-313404/)

drkwoods 03-15-2012 10:35 PM

5 Attachment(s)

Ok I got this sweet old Craftsman 11312130 motor that has the cap start on it. I want to wire a DPDT switch to run both directions. The sticker on the motor says switch the red n black terminals to reverse. How would I wire that to the switch. First pic is CCWR and second pic is CWR
The incoming power on the right is the wire nuts to the two right side terminals. The left side terminals are the ones I switched to reverse. The test works. Now to install the switch. Thank you!!


drkwoods 03-15-2012 10:35 PM

5 Attachment(s)

Ok I got this sweet old Craftsman 11312130 motor that has the cap start on it. I want to wire a DPDT switch to run both directions. The sticker on the motor says switch the red n black terminals to reverse. How would I wire that to the switch. First pic is CCWR and second pic is CWR
The incoming power on the right is the wire nuts to the two right side terminals. The left side terminals are the ones I switched to reverse. The test works. Now to install the switch. Thank you!!


drkwoods 03-15-2012 10:35 PM

5 Attachment(s)

Ok I got this sweet old Craftsman 11312130 motor that has the cap start on it. I want to wire a DPDT switch to run both directions. The sticker on the motor says switch the red n black terminals to reverse. How would I wire that to the switch. First pic is CCWR and second pic is CWR
The incoming power on the right is the wire nuts to the two right side terminals. The left side terminals are the ones I switched to reverse. The test works. Now to install the switch. Thank you!!


drkwoods 03-15-2012 10:35 PM

5 Attachment(s)

Ok I got this sweet old Craftsman 11312130 motor that has the cap start on it. I want to wire a DPDT switch to run both directions. The sticker on the motor says switch the red n black terminals to reverse. How would I wire that to the switch. First pic is CCWR and second pic is CWR
The incoming power on the right is the wire nuts to the two right side terminals. The left side terminals are the ones I switched to reverse. The test works. Now to install the switch. Thank you!!


drkwoods 03-15-2012 10:35 PM

5 Attachment(s)

Ok I got this sweet old Craftsman 11312130 motor that has the cap start on it. I want to wire a DPDT switch to run both directions. The sticker on the motor says switch the red n black terminals to reverse. How would I wire that to the switch. First pic is CCWR and second pic is CWR
The incoming power on the right is the wire nuts to the two right side terminals. The left side terminals are the ones I switched to reverse. The test works. Now to install the switch. Thank you!!


drkwoods 03-15-2012 11:35 PM

1 Attachment(s)

With the terminals off. #3 didn't have a terminal on it


drkwoods 03-23-2012 06:26 AM

1 Attachment(s)

Figured it out!!!! I had to get a 3PDT on-off-on switch. Down position is mill on normal. Middle off and up position is mill reversed. Here's what I did



All times are GMT. The time now is 12:58 AM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.