Just bought it a few hours ago. I've been playing with my DIY stirplate trying to find the right balance/distance for the magnets on the fan.
When I first started the stir bar would really stick right to where the magnet is and spin no problem at slow speed. But now, the stir bar barely wants to stay over the magnet when it's not moving. Add a little bit of rotation and forget it, it goes off to the side.
When I first bought it, I could easily test polarity by holding an end of the stir bar over the end of my hard drive magnet to see if it attracted or repelled. Now it seems to attract on both ends.
Is it possible that my hard drive rare-earth magnet was strong enough to demagnetize the stir-bar?
Location: NE Columbia SC - Formerly, Montreal Canada
Liked 139 Times on 113 Posts Likes Given: 42
It's a possibility, but doubtful. Are you spinning this in an erlenmeyer, or in a non-flat bottom vessel? Either way, try moving the container left-right, front-back and see if you can get it turning again.
Originally Posted by Misplaced_Canuck
Carbonic bite? Is that like the bubonic plague?
Originally Posted by ebstauffer
Needless to say after more than a few drams my mental efficiency matched my mashing efficiency.
I think i did demagnetize it somehow. I read on how to "remagetize" a magnet, basically continuously pass 1 end of a strong magnet over 1 end of the magnet that needs to be magnetized and i did this for a while, and now it seems to repel again at one end.