Center Inlet Chugger Pumps Mounting
Anyone have any advice for mounting these pumps? I'm going to hard plumb between three of the pumps on the same horizontal plane, with electronic valves to control flow. However, the outlets are slightly off from 90 degrees (see image of pump), which will cause issues when trying to run SS pipe between each fitting. Should I fabricate a mounts on my stand that are at an angle for the pump to bolt into, or maybe a welded mount, but use washers to introduce an angled to the mounted pump. Hope I'm making sense.. Any thoughts?
|All times are GMT. The time now is 02:19 PM.|
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.