So I was an idiot when I built my collared keezer, and mounted the insulation before installing the faucets. As such, I had a hard time getting the shank nuts tightened. I eventually resorted to some needle nose, and got them decently tight.
They're slowly coming loose though, so I need to really get a good grip on them. Any suggestions here? I just have a small circular cutout in the insulation for them, enough to get the pliers and a tad bit more in.
My last ditch effort would be to cut out the insulation below the taps, tighten them up, then re-mount the insulation, but I'd prefer not to have to, if possible.
Primary #1 (SS Brew Bucket):
Primary #2 (SS 7G Chronical):
Primary #3 (Better Bottle): Rye Saison
Secondary #1: Pinot Grigio Kit
Secondary #2: Pinot Grigio Kit
Secondary #3: Gewurztraminer Kit
Kegged & Waiting: Citra Black IPA
ON TAP: n/a
2014 Beers So Far:
Belgian Wit | Burton IPA | Belgian Wit | Black IPA | Rye Saison | Hefeweizen