Originally Posted by jmc922
..... Will my controller be hooked up correctly if I take the wires labeled
(smooth black) as my hot wire and connect to pins 1 & 7
(black white) as my neutral wire and connect to pin 2
(brown) as my compressor wire and connect to pin 8
Any input would be great. Not very good at reading these diagrams
I don't believe that's correct. Referencing the upper electrical schematic
, BLACKWHITE is the common point between the temperature control and compressor, it is NOT neutral.
In the upper left portion of the lower, wiring diagram
, SMOOTH / BLACK is constant hot but SMOOTH in the lower left is not. BROWN is the condensor fan hot, not the compressor hot.
Are you attempting to bypass or replace the temperature control with the STC1000? What portion of the wiring diagram do you have access to? I will assume the compressor, condensor fan, and the terminal block (polygon) are all in the lower section of the unit with the rest in another area? Is there a physical "FAN" switch?
If it is the upper portion of the diagram:
SMOOTH/BLACK to 1& 7
WHITE to 2
BLACKWHITE to 8
This will provide a bypass of the temperature control through the STC1000, however, the temperature control will still be functional and the condensor fan will be powered through the STC1000. I would also suggest disconnecting one of the temperature control wires.