Long story short i built a controller with two pids and changed my rig. Now i just need them to read temps but the one that was working read between 100F and 99F... This was even with no water touching the probe with a 74F room temp?! What is going on?
Found a good thread on HBT so i will tinker around again this afternoon. Really should have weighed my options before building this controller for a system that is completely different. Love controllers would have been perfect for the new simple set up I have.
I'm OCD so I may regret that they aren't all the same but the price was good so I jumped on it. I'm really just going to use the auber to display boil kettle temp and then temp of wort after it leaves the chiller