Originally Posted by DougEdey
Hi Jigen, if you read through the thread you should find discussion on setting up the Pi, I'm not an electrician and I've never seen 220V DC, but providing you have an SSR that works with it you should be fine. The current version of elsinore has a setup tool inbuilt that'll help to walk you through the initial configuration file setup.
I'm not actively working on this at the moment since I'm migrating the development to the beagleboard (I need the analogue IO for volume measurement readings, but this will be fed back to the pi based setup if you use a 1wire Analogue chip)
Thanks for the information.
In Italy we have AC 230V 50 HZ, I was wrong it is not DC.
The SSR should not give me problems with this type of power as I took these from ebay
So I have to first install Elsinore and then connect the sensors and SSR to the GPIOs?
Who could give me support for the installation of Elsinore?