Newest Threads

inhousebrew · 12-28-2012, 07:23 PM

Just looking at sourcing out a project box for this and no, I'm not going the easy route and just ordering one from the website. I know the screen on the outside is less than 2"x2" but how deep do they run into the box?

goybar · 12-28-2012, 08:16 PM

I would like to know this as well. Auber Ins. doesn't include this information.

I was thinking about using Console type enclosure like these:

http://www.automationdirect.com/adc/Overview/Catalog/Enclosures/Metal/NEMA_12_Consoles_-a-_Consolets/WC-C_Operator_Consolets

Chris

**jeffmeh** · 12-28-2012, 09:38 PM

Per Kal, you want 45mm x 45mm square holes for the 1/16 DIN devices, like the 2352 PID.

http://www.theelectricbrewery.com/control-panel-part-1?page=6

smittygouv30 · 12-28-2012, 10:03 PM

The 2352 is 100mm depth or 3.94 inches. This is straight from their downloadable manual.

Corey

inhousebrew · 12-28-2012, 10:03 PM

thanks for that. I must have missed it in the manual

smittygouv30 · 12-28-2012, 10:45 PM

No worries. I've been battling the same question. I want to order the auber enclosure 12x16x6 but am unsure how everything will fit. I think I'm gonna takes chance and try it anyway but certain things will have to be staggered as the PIDs are pretty deep.

goybar · 12-29-2012, 12:10 AM

I missed it too, I have looked though several times.

Thanks,

Chris