Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   Electric Brewing (http://www.homebrewtalk.com/f170/)
-   -   RIMS started (http://www.homebrewtalk.com/f170/rims-started-209112/)

jasonsbeer 12-01-2010 02:11 AM

RIMS started
Just had to share...

The parts for my RIMS tube showed up today from Murray Equipment. :ban:
This is a lot bigger than I had imagined it, which makes it even more awesome! Its all 1 1/2" stainless. I was going to put it together but I only had 3" of teflon tape left on my spool.

I just bought an electrical enclosure on e-bay and have been collecting other misc parts this fall. I still need to order parts from Auber, McMaster, and Mouser.


Justibone 12-01-2010 12:53 PM

Holy Schnikees! Is that a RIMS set-up or a boat anchor!! ;)


Layne 12-01-2010 01:29 PM

You're on your way!
I had great luck with my RIMS in a tool box. I used the same SS pieces from Murray.

gungadin 12-01-2010 01:32 PM

I know I've seen this in another thread a while back but couldn't find it again - can you point me to or post your parts list?

Layne 12-01-2010 01:39 PM

I don't have my list here at work, but this is all you need to know about RIMS.

gungadin 12-01-2010 01:49 PM

Thanks @Layne

JayInJersey 12-01-2010 04:08 PM

When I see that I see Winston Zeddemore sayin:

"That's a big twinkie"

stlbeer 12-01-2010 09:17 PM

I made my order to Murray today. Tomorrow I order the PID, SSR, Heat Sink, and RTD from Auber. My project box is an ammo box. Switches will be from the Shack.

jasonsbeer 12-01-2010 09:37 PM

The 1 1/2" SS was ~$50 + $16 S&H.

stlbeer 12-01-2010 09:58 PM


Originally Posted by jasonsbeer (Post 2444718)
The 1 1/2" SS was ~$50 + $16 S&H.

Was that just for the Tees and the large pipe? Did you order bushings too? My bill was about $66.

All times are GMT. The time now is 08:32 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.