Thanks for the quick response. However, you misunderstood me. I was only acknowledging that because it is a 220 motor, it will draw less amps than the same amount of power at 110--justifying smaller wire. I am wiring it to 220. And I am not making a pump--it IS a pump. It is a sweet pump that is magnetically driven and pure SS. I have only crudely tested it with water, but it creates lots of pressure. I see the "0,9 A" on the label, but that just seems low. But, I just looked at a march pump @ morebeer and it draws 1.4 amps @ 110 so apparently .9 amps is reasonable. Awesome. Thanks for helping me think it through.