I know its probably way overkill in terms of amps, but in short I am trying to whip together the makings of a very simplistic control box to drive a 3gal e-biab kettle. I have this ssr: http://www.auberins.com/index.php?ma...5c70acc81c22ec on hand along with the heatsink. I have a PID, probe and a plastic tool box, so I figured if I add in some terminal blocks, some salvaged extension cord wire and a 20amp gfci I could essentially stitch together a simple control box to power cycle on/off the 1500w element. I originally bought the 40amp ssr for plans on doing 5500w 220v setup, but I'm putting that on hold for the moment while I get back into the groove with the smaller batches since I have the kettle and parts to make it happen. Thoughts?