Hey guys, been a long and drawn out process but the end is near! Drilled out my enclosure yesterday, what a bitch that was. Word to the wise, do not buy a fiberglass enclosure and expect it to look pretty inside! I used a lot of tape to try and help, but the gelcoat and threading to make fiberglass chips very easily. Anyways, have all my components installed except for my key two switch. Can't figure out how to pull it apart to install it in the hole! Anyone have any advice?
Anyways, I am following my schematic I received from eBrewSupply.com and have a few questions, as this differs from a lot of others I have seen. Per this schematic, there are no fuses but I'd say everyone else's I have studied has fuses, am I just missing something? Second, what are the 120Va and 120vB with the 10ga wire running to it from the Contactor? Lastly, I am not going to install a timer and won't be installing a pump until later, is there anything I need to change to the schematic besides obviously not wiring anything up for it?
I will get pictures of my progress up tonight.
P.S. - How do I make a ground on a fiberglass box?